| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_aml: validate firmware segment lengths
aml_download_firmware() reads two lengths from the firmware header and
uses them to build pointers before checking that the header and segment
data are present. A truncated or inconsistent firmware image can make
the driver read past firmware->data while constructing TCI commands.
Reject images shorter than the header and ensure that the ICCM and DCCM
ranges fit within the loaded firmware before downloading either segment. |
| In the Linux kernel, the following vulnerability has been resolved:
nfc: nci: fix out-of-bounds write in nci_target_auto_activated()
nci_target_auto_activated() appends a target to the fixed-size array
ndev->targets[NCI_MAX_DISCOVERED_TARGETS] and increments ndev->n_targets
without first checking the array is full; unlike its sibling
nci_add_new_target(), which bails out when n_targets already equals
NCI_MAX_DISCOVERED_TARGETS.
ndev->n_targets is only cleared by nci_clear_target_list(), so an NFCC
that repeatedly re-runs discovery (RF_DISCOVER_RSP, which re-enters
NCI_DISCOVERY without clearing the target list) and reports an
auto-activated target (RF_INTF_ACTIVATED_NTF) drives n_targets past the
limit. The append then writes a struct nfc_target past the end of the
array (a slab out-of-bounds write), and nfc_targets_found() goes on to
walk the array with the inflated count:
BUG: KASAN: slab-out-of-bounds in nci_add_new_protocol+0x94/0x2ac [nci]
Write of size 2 at addr ffff0000c7299a18 by task kworker/u8:0/12
Workqueue: nfc0_nci_rx_wq nci_rx_work [nci]
Call trace:
nci_add_new_protocol+0x94/0x2ac [nci]
nci_ntf_packet+0xddc/0x11a0 [nci]
nci_rx_work+0x15c/0x1e0 [nci]
process_one_work+0x2dc/0x500
worker_thread+0x240/0x460
kthread+0x1c0/0x1d0
ret_from_fork+0x10/0x20
The buggy address belongs to the cache kmalloc-2k of size 2048
The buggy address is located 1024 bytes to the right of
allocated 1560-byte region [ffff0000c7299000, ffff0000c7299618)
Guard nci_target_auto_activated() with the same check used by
nci_add_new_target(). |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_event: validate LE Set CIG Parameters response
The Command Complete dispatch validates only the fixed part of the LE Set
CIG Parameters response. After that part is pulled from the skb,
hci_cc_le_set_cig_params() trusts num_handles and reads each entry in the
trailing handle array.
Matching num_handles against the command's num_cis does not guarantee
that the response contains the advertised handles. A truncated response
from a malfunctioning controller can therefore make the handler read
beyond the skb data.
Validate that the remaining skb data contains all advertised handles.
Include this in the existing response validation so malformed responses
also follow the established CIG failure handling. |
| A vulnerability was detected in valkey-io valkey up to 9.5.4/9.1.0. Affected by this vulnerability is the function createSlotImportJob of the file src/cluster_migrateslots.c of the component Slot Migration. The manipulation of the argument job_name results in out-of-bounds read. The attack can be executed remotely. The exploit is now public and may be used. Upgrading to version 9.0.5 and 9.1.1 addresses this issue. The patch is identified as f4dc3ca09eb650c2fe14060090a41c524eca803f. Upgrading the affected component is advised. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: btnxpuart: Fix out-of-bounds firmware read in nxp_recv_fw_req_v3()
During the v3 firmware download the controller sends a v3_data_req with a
32 bit offset and a 16 bit len. nxp_recv_fw_req_v3() checks only the lower
bound of the offset and then sends firmware from that offset.
nxpdev->fw_dnld_v3_offset = offset - nxpdev->fw_v3_offset_correction;
serdev_device_write_buf(nxpdev->serdev, nxpdev->fw->data +
nxpdev->fw_dnld_v3_offset, len);
Nothing checks that fw_dnld_v3_offset + len stays within nxpdev->fw->size,
so a controller that asks for an offset or length past the firmware image
makes the driver read past the end of nxpdev->fw->data and send that
memory back over UART.
nxp_recv_fw_req_v1() already bounds the same write. Add the equivalent
check to the v3 path, reject the request when it falls outside the firmware
image, and zero len on the error path so the fw_v3_prev_sent bookkeeping at
free_skb stays consistent. |
| Denial-of-service vulnerabilities exist in the command line interface of AOS-CX. Successful exploitation could allow an authenticated user to disrupt the normal operation of a vulnerable system. |
| In the Linux kernel, the following vulnerability has been resolved:
net: remove CAP_SYS_RAWIO zero-padding in dev_validate_header
dev_validate_header() reads dev->hard_header_len directly when
zero-padding short link layer headers for CAP_SYS_RAWIO holders:
if (capable(CAP_SYS_RAWIO)) {
memset(ll_header + len, 0, dev->hard_header_len - len);
return true;
}
Packet send paths call dev_validate_header() on skbs whose headroom was
allocated from an earlier hard_header_len read. If the device is
reconfigured so that dev->hard_header_len increases before validation,
the memset writes past the reserved buffer, an out-of-bounds write.
This out-of-bounds write is masked in some SOCK_RAW paths today because
the same concurrent increase can first make skb_push() exceed the
reserved headroom and trigger skb_under_panic(). Remove the zero-padding
branch before making those hard_header_len reads consistent, so the
snapshot fixes do not turn a loud panic into a silent overwrite.
This path is only reached for variable length L2 protocols, where
len < hard_header_len but len >= min_header_len. No remaining in-tree
variable length L2 protocol implements header_ops->validate, and the
CAP_SYS_RAWIO bypass that zero-pads and accepts short headers has no
real value beyond allowing testing of intentionally malformed input.
Drop the CAP_SYS_RAWIO branch. The remaining reads of
dev->hard_header_len in dev_validate_header() are comparisons only and
have no memory safety impact. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/connector/hdmi: Fix out of bounds memory read
A helper function was copying a given audio infoframe into the
connector's copy but using the size of the destination (a generic
target, sized to accept many different data blocks) not the source (a
very specific type of data block). Thus, it was copying 60 bytes of
data from a 28 byte allocation.
Fix that by using the source size instead, together with a build bug
on the source size actually being smaller than the destination.
I hit this running KUnit tests under KASAN (while debugging something
else entirely). In the real world, it seems unlikely to cause an
actual problem. It is a read not a write so it can't corrupt any
memory. However, it could potentially fall off the end of a page and
cause an accvio bug. |
| Internally found bugs present in Thunderbird 154 and Thunderbird ESR 153.1. Some of these bugs showed evidence of memory corruption or another security-relevant defect and we presume that with enough effort some of these could have been exploited. This vulnerability was fixed in Firefox 155, Firefox ESR 153.2, Thunderbird 155, and Thunderbird 153.2. |
| Internally found bugs present in Thunderbird 154. Some of these bugs showed evidence of memory corruption or another security-relevant defect and we presume that with enough effort some of these could have been exploited. This vulnerability was fixed in Firefox 155 and Thunderbird 155. |
| Internally found bugs present in Thunderbird 154, Thunderbird ESR 153.1 and Thunderbird ESR 140.14. Some of these bugs showed evidence of memory corruption or another security-relevant defect and we presume that with enough effort some of these could have been exploited. This vulnerability was fixed in Firefox 155, Firefox ESR 140.15, Firefox ESR 153.2, Thunderbird 155, Thunderbird 140.15, and Thunderbird 153.2. |
| A vulnerability was identified in Tenda HG10 300001138. Impacted is the function formWlanSetup of the file /boaform/formWlanSetup of the component Boa Web Server. The manipulation of the argument ssid leads to buffer overflow. Remote exploitation of the attack is possible. The exploit is publicly available and might be used. |
| A vulnerability was determined in Tenda HG10 300001138. This issue affects the function formLogin of the file /boaform/formLogin of the component Boa Web Server. Executing a manipulation of the argument Username can lead to buffer overflow. The attack may be launched remotely. The exploit has been publicly disclosed and may be utilized. |
| A single crafted SSH message gives an unauthenticated network attacker an out-of-bounds stack write of attacker-controlled length and content against any application built on swift-nio-ssh. This vulnerability is addressed in swift-nio-ssh version 0.14.1. |
| A vulnerability was found in TOTOLINK CP450 4.1.0. The impacted element is an unknown function of the file /cgi-bin/cstecgi.cgi. Performing a manipulation of the argument topicurl results in buffer overflow. Remote exploitation of the attack is possible. |
| Internally found bugs present in Thunderbird 154, Thunderbird ESR 153.1 and Thunderbird ESR 140.14. Some of these bugs showed evidence of memory corruption or another security-relevant defect and we presume that with enough effort some of these could have been exploited. This vulnerability was fixed in Firefox 155, Firefox ESR 115.40, Firefox ESR 140.15, Firefox ESR 153.2, Thunderbird 155, Thunderbird 140.15, and Thunderbird 153.2. |
| Vulnerability in Drupal Gammu SMS Daemon. This issue affects Gammu SMS Daemon versions: *.*. |
| No description is available for this CVE. |
| Vulnerability in Drupal Gammu SMS Daemon. This issue affects Gammu SMS Daemon versions: *.*. |
| Vulnerability in Drupal Gammu SMS Daemon. This issue affects Gammu SMS Daemon versions: *.*. |
