| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A vulnerability in dynamic access policies (DAP) functionality of Cisco Adaptive Security Appliance (ASA) Software and Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause an affected device to reload, resulting in a denial of service (DoS) condition.
This vulnerability is due to improper processing of HostScan data received from the Posture (HostScan) module. An attacker could exploit this vulnerability by sending crafted HostScan data to an affected device. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a DoS condition.
https://tools.cisco.com/security/center/content/CiscoSecurityAdvisory/cisco-sa-asa-ftd-dap-dos-GhYZBxDU ["https://tools.cisco.com/security/center/content/CiscoSecurityAdvisory/cisco-sa-asa-ftd-dap-dos-GhYZBxDU"]
This advisory is part of the November 2022 release of the Cisco ASA, FTD, and FMC Security Advisory Bundled publication. |
| A vulnerability in the management web server of Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, remote attacker with high privileges to execute configuration commands on an affected system.
This vulnerability exists because access to HTTPS endpoints is not properly restricted on an affected device. An attacker could exploit this vulnerability by sending specific messages to the affected HTTPS handler. A successful exploit could allow the attacker to perform configuration changes on the affected system, which should be configured and managed only through Cisco Firepower Management Center (FMC) Software. |
| A vulnerability in the detection engine of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, adjacent attacker to send data directly to the kernel of an affected device. The vulnerability exists because the software improperly filters Ethernet frames sent to an affected device. An attacker could exploit this vulnerability by sending crafted packets to the management interface of an affected device. A successful exploit could allow the attacker to bypass the Layer 2 (L2) filters and send data directly to the kernel of the affected device. A malicious frame successfully delivered would make the target device generate a specific syslog entry. |
| Multiple vulnerabilities in the Server Message Block (SMB) Protocol preprocessor detection engine for Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, adjacent or remote attacker to cause a denial of service (DoS) condition. For more information about these vulnerabilities, see the Details section of this advisory. |
| A vulnerability in the upgrade process of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, local attacker to inject commands that could be executed with root privileges on the underlying operating system (OS). This vulnerability is due to insufficient input validation. An attacker could exploit this vulnerability by uploading a crafted upgrade package file to an affected device. A successful exploit could allow the attacker to inject commands that could be executed with root privileges on the underlying OS. |
| Multiple vulnerabilities in the WebVPN service of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, remote attacker to conduct a cross-site scripting (XSS) attack against a user of the WebVPN portal of an affected device. The vulnerabilities exist because the software insufficiently validates user-supplied input on an affected device. An attacker could exploit these vulnerabilities by persuading a user of the interface to click a crafted link. A successful exploit could allow the attacker to execute arbitrary script code in the context of the affected interface or access sensitive browser-based information. An attacker would need administrator privileges on the device to exploit these vulnerabilities. |
| A vulnerability in the interaction of SIP and Snort 3 for Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause the Snort 3 detection engine to restart.
This vulnerability is due to a lack of error-checking when SIP bidirectional flows are being inspected by Snort 3. An attacker could exploit this vulnerability by sending a stream of crafted SIP traffic through an interface on the targeted device. A successful exploit could allow the attacker to trigger a restart of the Snort 3 process, resulting in a denial of service (DoS) condition. |
| A vulnerability in the implementation of Security Assertion Markup Language (SAML) 2.0 single sign-on (SSO) for remote access VPN in Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to intercept the SAML assertion of a user who is authenticating to a remote access VPN session. This vulnerability is due to insufficient validation of the login URL. An attacker could exploit this vulnerability by persuading a user to access a site that is under the control of the attacker, allowing the attacker to modify the login URL. A successful exploit could allow the attacker to intercept a successful SAML assertion and use that assertion to establish a remote access VPN session toward the affected device with the identity and permissions of the hijacked user, resulting in access to the protected network. |
| A vulnerability in the AnyConnect SSL VPN feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, remote attacker to send packets with another VPN user's source IP address. This vulnerability is due to improper validation of the packet's inner source IP address after decryption. An attacker could exploit this vulnerability by sending crafted packets through the tunnel. A successful exploit could allow the attacker to send a packet impersonating another VPN user's IP address. It is not possible for the attacker to receive return packets. |
| A vulnerability in the file policy feature that is used to inspect encrypted archive files of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to bypass a configured file policy to block an encrypted archive file. This vulnerability exists because of a logic error when a specific class of encrypted archive files is inspected. An attacker could exploit this vulnerability by sending a crafted, encrypted archive file through the affected device. A successful exploit could allow the attacker to send an encrypted archive file, which could contain malware and should have been blocked and dropped at the Cisco FTD device. |
| A vulnerability in the Simple Network Management Protocol (SNMP) feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, remote attacker to cause an unexpected reload of the device.
This vulnerability is due to insufficient input validation of SNMP packets. An attacker could exploit this vulnerability by sending a crafted SNMP request to an affected device using IPv4 or IPv6. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a denial of service (DoS) condition. This vulnerability affects all versions of SNMP (versions 1, 2c, and 3) and requires a valid SNMP community string or valid SNMPv3 user credentials. |
| A vulnerability in the activation of an access control list (ACL) on Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to bypass the protection that is offered by a configured ACL on an affected device. This vulnerability is due to a logic error that occurs when an ACL changes from inactive to active in the running configuration of an affected device. An attacker could exploit this vulnerability by sending traffic through the affected device that should be denied by the configured ACL. The reverse condition is also true—traffic that should be permitted could be denied by the configured ACL. A successful exploit could allow the attacker to bypass configured ACL protections on the affected device, allowing the attacker to access trusted networks that the device might be protecting. Note: This vulnerability applies to both IPv4 and IPv6 traffic as well as dual-stack ACL configurations in which both IPv4 and IPv6 ACLs are configured on an interface. |
| A vulnerability in the AnyConnect firewall for Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to bypass a configured access control list (ACL) and allow traffic that should have been denied to flow through an affected device. This vulnerability is due to a logic error in populating group ACLs when an AnyConnect client establishes a new session toward an affected device. An attacker could exploit this vulnerability by establishing an AnyConnect connection to the affected device. A successful exploit could allow the attacker to bypass configured ACL rules. |
| A vulnerability in the packet processing functionality of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. The vulnerability is due to inefficient memory management. An attacker could exploit this vulnerability by sending a large number of TCP packets to a specific port on an affected device. A successful exploit could allow the attacker to exhaust system memory, which could cause the device to reload unexpectedly. No manual intervention is needed to recover the device after it has reloaded. |
| A vulnerability in the CLI of Cisco FXOS Software and Cisco UCS Manager Software could allow an authenticated, local attacker to execute arbitrary commands on the underlying operating system (OS). The vulnerability is due to insufficient input validation. An attacker could exploit this vulnerability by including crafted arguments to specific commands. A successful exploit could allow the attacker to execute arbitrary commands on the underlying OS with the privileges of the currently logged-in user for all affected platforms excluding Cisco UCS 6400 Series Fabric Interconnects. On Cisco UCS 6400 Series Fabric Interconnects, the injected commands are executed with root privileges. |
| A vulnerability in the web services interface of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to retrieve memory contents on an affected device, which could lead to the disclosure of confidential information. The vulnerability is due to a buffer tracking issue when the software parses invalid URLs that are requested from the web services interface. An attacker could exploit this vulnerability by sending a crafted GET request to the web services interface. A successful exploit could allow the attacker to retrieve memory contents, which could lead to the disclosure of confidential information. Note: This vulnerability affects only specific AnyConnect and WebVPN configurations. For more information, see the Vulnerable Products section. |
| A vulnerability in the HTTP traffic filtering component of Cisco Firepower Threat Defense Software, Cisco FirePOWER Services Software for ASA, and Cisco Firepower Management Center Software could allow an unauthenticated, remote attacker to bypass filtering protections. The vulnerability is due to improper handling of HTTP requests, including those communicated over a secure HTTPS connection, that contain maliciously crafted headers. An attacker could exploit this vulnerability by sending malicious requests to an affected device. An exploit could allow the attacker to bypass filtering and deliver malicious requests to protected systems, allowing attackers to deliver malicious content that would otherwise be blocked. |
| A vulnerability in the inter-device communication mechanisms between devices that are running Cisco Firepower Threat Defense (FTD) Software and devices that are running Cisco Firepower Management (FMC) Software could allow an authenticated, local attacker to execute arbitrary commands with root permissions on the underlying operating system of an affected device.
This vulnerability is due to insufficient validation of user-supplied input. An attacker could exploit this vulnerability by accessing the expert mode of an affected device and submitting specific commands to a connected system. A successful exploit could allow the attacker to execute arbitrary code in the context of an FMC device if the attacker has administrative privileges on an associated FTD device. Alternatively, a successful exploit could allow the attacker to execute arbitrary code in the context of an FTD device if the attacker has administrative privileges on an associated FMC device. |
| A vulnerability in the implementation of Security Assertion Markup Language (SAML) 2.0 Single Sign-On (SSO) for Clientless SSL VPN (WebVPN) and AnyConnect Remote Access VPN in Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to successfully establish a VPN session to an affected device. The vulnerability is due to improper credential management when using NT LAN Manager (NTLM) or basic authentication. An attacker could exploit this vulnerability by opening a VPN session to an affected device after another VPN user has successfully authenticated to the affected device via SAML SSO. A successful exploit could allow the attacker to connect to secured networks behind the affected device. |
| A vulnerability in the Internet Key Exchange Version 2 Mobility and Multihoming Protocol (MOBIKE) feature for the Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a memory leak or a reload of an affected device that leads to a denial of service (DoS) condition. The vulnerability is due to the incorrect processing of certain MOBIKE packets. An attacker could exploit this vulnerability by sending crafted MOBIKE packets to an affected device to be processed. A successful exploit could cause an affected device to continuously consume memory and eventually reload, resulting in a DoS condition. The MOBIKE feature is supported only for IPv4 addresses. |
